Producing diesel oil through pyrolysis of tires？
Pyrolysis tire oil to diesel plant
Waste tires contain big tires and small tires, by using DOING waste tire pyrolysis plant can turn waste tires into crude oil, oil rate for big tires is 45%-50%, for small tyres is 35%-40%. We also have pyrolysis tire oil to diesel plant, which can turn crude oil from pyrolysis plant to diesel, diesel rate for big tires is 40%-45%, and for small tires is 31%-36%
From 10 ton waste tires, big tires can get 4.5-5 ton crude oil or 4-4.5 ton diesel. While small tires can get 3.5-4 ton crude oil or 3-3.5 ton diesel. Please see the following form.
|
Raw materials |
Crude oil rate |
Diesel oil rate |
|
Big tyres |
45%-50% |
40%-45% |
|
Small tyres |
35%-40% |
31%-36% |
Oil capacity from 10 ton waste tires:
Note:Crude oil and diesel can not get at the same time. Crude oil produced by waste tyre pyrolysis plant, diesel is the refining of crude oil produced pyrolysis tire oil to diesel plant.
Pyrolysis tire oil to diesel plant
|
Capacity |
Raw materials |
Crude oil(T) |
Diesel(T) |
|
10T |
Big tyres |
4.5-5T |
4-4.5T |
|
10T |
Small tyres |
3.5-4T |
3-3.5T |
Producing diesel oil through pyrolysis of tires？
Pyrolysis tire oil to diesel plant working processing
1.pump the waste oil into reactor by oil pump.
2.use coal/wood/natural gas/fuel oil/electricity heating the reactor.
3.after heating some time, the liquid oil will become oil gas, oil gas will be liquefied by the cooling pipe and condensers then will go into oil tank. Here we get mixed oil, or you can also call it fuel oil. If you wanna get diesel and gasoline separately, through temperature control could separate it and collected into two different oil tanks.
4.some gases (syngas) like Methane, Ethane, Propane, Butane, and Hydrogen cannot be liquefied under normal pressure and normal temperature will be recycled to fire furnace heating the reactor.
5.when use burning material heating the reactor, will produce some smoke. These smokes will go into our de-dusting system, the inside we design some high pressure nozzles, these nozzles will spraying some chemical water, the dust will be absorbed by the chemical water and flowing into the de-dusting pool. In the pool we will put some chemical which could remove the sulfur.
6.the exhaust gas will go into the chimney sucked by draft fan, when emission the exhaust gas will become steam, no pollution.
